Heating and Air Conditioning services managed in New York City
Repair, maintenance and replacement of furnaces, air conditioners, heat pumps and boilers. Managed by Residence First and carried out by licensed local HVAC providers.
- Air conditioner and heat pump repair
- Furnace and boiler repair
- Seasonal tune-ups before heating and cooling seasons
- System replacement and new installation
- Thermostat and zoning controls
- Ductwork repair and indoor air quality equipment
The full scope is described on the heating and air conditioning service page.
Licensing and permits for HVAC in New York City
HVAC work in New York City is assigned only to providers who meet the requirements below, and permits are obtained where the work requires them.
HVAC work in New York City is split across several credentials.
| Requirement | Agency | Level | Official source |
|---|---|---|---|
| Section 608 certification for technicians who service equipment that could release refrigerant | U.S. Environmental Protection Agency | Federal | EPA: Section 608 Technician Certification |
| Oil Burner Equipment Installer license (Class A for any oil-burning equipment, Class B for No. 1 to No. 4 oils) | NYC Department of Buildings | City | DOB: Oil Burner Equipment Installer |
| Licensed Master Plumber for gas piping and equipment replacement done as ordinary maintenance | NYC Department of Buildings | City | DOB: Does my project require a permit? |
| Licensed Master Electrician for electrical work | NYC Department of Buildings | City | DOB: Know Your Construction Professional |
| Refrigerating system permit, and a Refrigerating System Operating Engineer (Q-01) for larger systems | FDNY | City | FDNY: Refrigerating System Permit |
| Annual low-pressure boiler inspection by a DOB-authorized boiler inspector | NYC Department of Buildings | City | DOB: Low-Pressure Boiler Requirements |
This information was checked on official sites in November 2026. Requirements for work on homes can differ from other building types, and they change, so the license for each job is confirmed before work is assigned.
Seasonal conditions in New York City
- Heating season. Boiler and furnace failures are among the most urgent calls in cold months. Fall start-ups, burner checks and the annual boiler inspection are scheduled before the first cold spell.
- Storm season. NYC Emergency Management notes that the Atlantic hurricane season runs from June 1 to November 30, with the greatest risk from August through October.
Common reasons for a request
- No heating or no cooling
- Weak airflow or uneven temperatures between rooms
- Unusual noise, odor or short cycling
- Rising energy use with no change in habits
How a request works in New York City
Frequently asked questions
Who carries out HVAC work in New York City?
A local provider from the Residence First network who holds the license the work requires in New York City. Residence First assigns the provider, follows the job and checks the finished work.
Can one request cover both heating and cooling equipment?
Yes. A single request can cover every heating and cooling system in the home, and each system is recorded separately so its service history stays clear.
Is HVAC service available for rental properties and associations in New York City?
Yes. Landlords, property managers, homeowners associations and condominium boards in New York City use the same request process as homeowners.