Heating and Air Conditioning services managed in Seattle
Repair, maintenance and replacement of furnaces, air conditioners, heat pumps and boilers. Managed by Residence First and carried out by licensed local HVAC providers.
- Air conditioner and heat pump repair
- Furnace and boiler repair
- Seasonal tune-ups before heating and cooling seasons
- System replacement and new installation
- Thermostat and zoning controls
- Ductwork repair and indoor air quality equipment
The full scope is described on the heating and air conditioning service page.
Licensing and permits for HVAC in Seattle
HVAC work in Seattle is assigned only to providers who meet the requirements below, and permits are obtained where the work requires them.
Seattle licenses refrigeration and air conditioning work at the City level, in addition to state contractor registration. Mechanical, refrigeration, boiler and gas work each have their own permits.
| Requirement | Agency | Level | Official source |
|---|---|---|---|
| Construction contractor registration, with bond and liability insurance; HVAC is one of the registered specialties | Washington State Department of Labor and Industries | State | L&I: Register as a Contractor |
| Gas piping mechanic license for piping from the meter to the appliance | SDCI | City | SDCI: Gas Pipe Licensing |
| Boiler inspection each year and pressure vessel inspection every two years, with the Certificate of Inspection displayed next to the equipment | SDCI | City | SDCI: Boiler and Pressure Vessel Inspections FAQ |
This information was checked on official sites in November 2026. Requirements for work on homes can differ from other building types, and they change, so the license for each job is confirmed before work is assigned.
Seasonal conditions in Seattle
- Heating season. Mild temperatures still call for seasonal servicing, and heating tune-ups are scheduled ahead of the wet months that the City’s stormwater rules define as October 1 to April 30.
- Cooling season. Cooling checks, coil cleaning and condensate drain clearing are done in spring, ahead of summer warm spells.
- Electrification. For buildings covered by the building performance rules above, gas-to-heat-pump conversion is weighed at every major replacement.
Common reasons for a request
- No heating or no cooling
- Weak airflow or uneven temperatures between rooms
- Unusual noise, odor or short cycling
- Rising energy use with no change in habits
How a request works in Seattle
Frequently asked questions
Who carries out HVAC work in Seattle?
A local provider from the Residence First network who holds the license the work requires in Seattle. Residence First assigns the provider, follows the job and checks the finished work.
Can one request cover both heating and cooling equipment?
Yes. A single request can cover every heating and cooling system in the home, and each system is recorded separately so its service history stays clear.
Is HVAC service available for rental properties and associations in Seattle?
Yes. Landlords, property managers, homeowners associations and condominium boards in Seattle use the same request process as homeowners.